diff options
Diffstat (limited to 'nixos/doc/manual/configuration/ipv4-config.xml')
-rw-r--r-- | nixos/doc/manual/configuration/ipv4-config.xml | 15 |
1 files changed, 4 insertions, 11 deletions
diff --git a/nixos/doc/manual/configuration/ipv4-config.xml b/nixos/doc/manual/configuration/ipv4-config.xml index 71ddf41491b..3ebde2193cb 100644 --- a/nixos/doc/manual/configuration/ipv4-config.xml +++ b/nixos/doc/manual/configuration/ipv4-config.xml @@ -6,17 +6,14 @@ <title>IPv4 Configuration</title> <para> - By default, NixOS uses DHCP (specifically, <command>dhcpcd</command>) to - automatically configure network interfaces. However, you can configure an - interface manually as follows: + By default, NixOS uses DHCP (specifically, <command>dhcpcd</command>) to automatically configure network interfaces. However, you can configure an interface manually as follows: <programlisting> <link linkend="opt-networking.interfaces._name__.ipv4.addresses">networking.interfaces.eth0.ipv4.addresses</link> = [ { address = "192.168.1.2"; prefixLength = 24; } ]; </programlisting> - Typically you’ll also want to set a default gateway and set of name - servers: + Typically you’ll also want to set a default gateway and set of name servers: <programlisting> <xref linkend="opt-networking.defaultGateway"/> = "192.168.1.1"; <xref linkend="opt-networking.nameservers"/> = [ "8.8.8.8" ]; @@ -25,10 +22,7 @@ <note> <para> - Statically configured interfaces are set up by the systemd service - <replaceable>interface-name</replaceable><literal>-cfg.service</literal>. - The default gateway and name server configuration is performed by - <literal>network-setup.service</literal>. + Statically configured interfaces are set up by the systemd service <replaceable>interface-name</replaceable><literal>-cfg.service</literal>. The default gateway and name server configuration is performed by <literal>network-setup.service</literal>. </para> </note> @@ -37,7 +31,6 @@ <programlisting> <xref linkend="opt-networking.hostName"/> = "cartman"; </programlisting> - The default host name is <literal>nixos</literal>. Set it to the empty string - (<literal>""</literal>) to allow the DHCP server to provide the host name. + The default host name is <literal>nixos</literal>. Set it to the empty string (<literal>""</literal>) to allow the DHCP server to provide the host name. </para> </section> |