diff options
Diffstat (limited to 'nixos/doc/manual/configuration/file-systems.xml')
-rw-r--r-- | nixos/doc/manual/configuration/file-systems.xml | 9 |
1 files changed, 5 insertions, 4 deletions
diff --git a/nixos/doc/manual/configuration/file-systems.xml b/nixos/doc/manual/configuration/file-systems.xml index 3ac02a975eb..42c59844ff4 100644 --- a/nixos/doc/manual/configuration/file-systems.xml +++ b/nixos/doc/manual/configuration/file-systems.xml @@ -23,12 +23,12 @@ <link xlink:href="https://www.freedesktop.org/software/systemd/man/systemd-fstab-generator.html">systemd-fstab-generator</link>. The filesystem will be mounted automatically unless <literal>"noauto"</literal> is present in <link - linkend="opt-fileSystems._name__.options">options</link>. + linkend="opt-fileSystems._name_.options">options</link>. <literal>"noauto"</literal> filesystems can be mounted explicitly using <command>systemctl</command> e.g. <command>systemctl start data.mount</command>. Mount points are created automatically if they don’t already exist. For - <option><link linkend="opt-fileSystems._name__.device">device</link></option>, + <option><link linkend="opt-fileSystems._name_.device">device</link></option>, it’s best to use the topology-independent device aliases in <filename>/dev/disk/by-label</filename> and <filename>/dev/disk/by-uuid</filename>, as these don’t change if the @@ -36,7 +36,7 @@ </para> <para> You can usually omit the file system type - (<option><link linkend="opt-fileSystems._name__.fsType">fsType</link></option>), + (<option><link linkend="opt-fileSystems._name_.fsType">fsType</link></option>), since <command>mount</command> can usually detect the type and load the necessary kernel module automatically. However, if the file system is needed at early boot (in the initial ramdisk) and is not <literal>ext2</literal>, @@ -49,9 +49,10 @@ System startup will fail if any of the filesystems fails to mount, dropping you to the emergency shell. You can make a mount asynchronous and non-critical by adding - <literal><link linkend="opt-fileSystems._name__.options">options</link> = [ + <literal><link linkend="opt-fileSystems._name_.options">options</link> = [ "nofail" ];</literal>. </para> </note> <xi:include href="luks-file-systems.xml" /> + <xi:include href="../from_md/configuration/sshfs-file-systems.section.xml" /> </chapter> |